As new device firmware is released, it can be downloaded with the latest version of MPLAB X IDE, free of charge. The firmware is continually being updated to add support for new devices. For the current list of supported parts, review the latest release notes located in the MPLAB IDE and attached below. MPLAB ICD 3 In-Circuit Debugger/Programmer supports most Flash PIC MCUs and dsPIC DSCs. MPLAB ICD 3 has improved speed as compared with MPLAB ICD 2. MPLAB ICD 3 supports all Emulation headers. The MPLAB ICD 3 In-Circuit Debugger probe is connected to the design engineer's PC using a high-speed USB 2.0 interface and is connected to the target with a connector compatible with the MPLAB ICD 2 or MPLAB REAL ICE systems (RJ-11). It debugs and programs PIC® Flash microcontrollers and dsPIC® DSCs with the powerful, yet easy-to-use graphical user interface of MPLAB Integrated Development Environment (IDE). MPLAB® ICD 3 In-Circuit Debugger System is Microchip's most cost effective high-speed hardware debugger/programmer for Microchip Flash Digital Signal Controller (DSC) and microcontroller (MCU) devices.

Support of a wide choice of Integrated Development Environments (IDEs) including IAR в„ў, Keil В®, GCC-based IDEs, ARM В® mbed Enabled в„ў.

Comprehensive free software HAL library including a variety of examples, as part of the STM32Cube package.

On-board ST-LINK/V2-1 debugger/programmer with USB re-enumeration capability: mass storage, virtual COM port and debug port.

Time-of-Flight and gesture-detection sensor (VL53L0X).

260-1260 hPa absolute digital output barometer (LPS22HB).

3D accelerometer and 3D gyroscope (LSM6DSL).

High-performance 3-axis magnetometer (LIS3MDL).

Capacitive digital sensor for relative humidity and temperature (HTS221).

2 digital omnidirectional microphones (MP34DT01).

Dynamic NFC tag based on M24SR with its printed NFC antenna.

Sub-GHz (868 or 915 MHz) low-power-programmable RF module (SPSGRF-868 or SPSGRF-915).

64-Mbit Quad-SPI (Macronix) Flash memory.

Ultra-low-power STM32L4 Series MCUs based on ARM В® Cortex В® -M4 core with 1 Mbyte of Flash memory and 128 Kbytes of SRAM, in LQFP100 package.

Data Gateway Interface: SPI, I2C, 4 GPIOs.

Symbolic debug of complex data types including scope information.

Auto-ID for board identification in Atmel Studio.

Arduino due compatible shield connectors.

Stereo audio codec - External PLL for precise clock generation.

AT24MAC402 256KByte EEPROM with EUI-48 address.

IEEE 802.3az 10Base-T/100Base-TX with KSZ8061 Ethernet PHY via RMII.

Zadig driver for lux flight controller